JD-2000™
TECHNICAL PRODUCT BULLETIN #D-7
USEPA, OEM REGULATIONS IMPLEMENTATION DIVISION
ORIGINAL LISTING DATE: AUGUST 6, 2001
"JD-2000™"
I. NAME, BRAND, OR TRADEMARK |
---|
JD-2000™ Type of Product: Dispersant |
II. NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT |
---|
GlobeMark Resources Ltd. 1312 Mill Creek Drive Salado, TX 76571 Mobile: (254) 231-2251 Email: [email protected] or [email protected] Web Site: http://www.globemarkresources.com (Ms. Joannie Docter) |
III. NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS |
---|
GlobeMark Resources Ltd. 1312 Mill Creek Drive Salado, TX 76571 Mobile: (254) 231-2251 Email: [email protected] or [email protected] Web Site: http://www.globemarkresources.com (Ms. Joannie Docter) |
IV. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION |
---|
1. Flammability: IMO - Non-flammable. This product is not regulated by DOT when shipped domestically by land. 2. Ventilation: Use with ventilation equal to unobstructed outdoors in a moderate breeze. 3. Skin and eye contact; protective clothing; treatment in case of contact: Avoid skin and clothing contact. If skin contact occurs, immediately wash with large amounts of water and soap (if possible). Remove any contaminated clothing or shoes. Launder before reusing. If irritation persists, seek medical assistance. For areas where contact is likely, wear long sleeve shirt, chemical resistant gloves, and chemical resistant goggles. 4.a. Maximum storage temperature: 120ºF 4.b. Minimum storage temperature: -30ºF 4.c. Optimum storage temperature range: 30ºF to 90ºF 4.d. Temperatures of phase separations and chemical changes: None |
V. SHELF LIFE |
---|
The shelf life of unopened drums of JD-2000™ is unlimited. Containers should be capped when not being used to prevent contamination and evaporation. Opened container should be used within 1 year for optimal performance. Poly containers are recommended for storage near wet environments, i.e., ships, harbors, ports, etc. |
VI. RECOMMENDED APPLICATION PROCEDURE |
---|
1. Application Method: JD-2000™ is free of phosphates, aromatic chlorinated solvents, branched ethoxylated alcohols, and hydrotreated distillates. Optimum temperature for application is above 30ºF. Aerial Spraying - Typical application altitudes of 30 to 50 feet are advised although higher altitudes may be used if conditions warrant. Spray nozzle should be about ¼ inch in diameter flying at 104 knots or more to create enough air shear sufficient to break the dispersant into proper sized droplets. A ½ inch diameter nozzle may be needed for temperatures from 30ºF to -30ºF. Boat Spraying - JD-2000™ can also be applied by workboats with spray booms mounted as far forward as possible of the bow or wake. The most effective application from a workboat is a low-volume, low-pressure pump. 2. Concentration/Application Rate: JD-2000™ is an oil spill dispersant concentrate that may be diluted by 5 to 10 percent with water if needed. A treatment rate of about 2 to 10 U.S. gallons (7.6 to 37.9 liters) per acre (4,840 square meters) or a dispersant to oil ratio of 1:50 to 1:10 is recommended. The rate may vary depending on the type of oil, degree of weathering, temperature, and thickness of slick. 3. Conditions for Use: As with any oil related spill, timely (preferably within 48 hours) application of a dispersant will ensure the highest degree of success. Timely treatment with JD-2000™, even at low application rates, can counter the "mousse" forming effect of the spilled oil. |
VII. TOXICITY AND EFFECTIVENESS | |||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1. Toxicity
2. Effectiveness: SWIRLING FLASK DISPERSANT EFFECTIVENESS TEST WITH SOUTH LOUISIANA (S/L) AND PRUDHOE BAY (P/B) CRUDE OIL
|
VIII. MICROBIOLOGICAL ANALYSIS |
---|
NA |
IX. PHYSICAL PROPERTIES |
---|
1. Flash Point (SW1010): 212ºF 2. Pour Point (ASTM D97): -36ºF 3. Viscosity (ASTM D445): 65.2 cst 4. Specific Gravity 60/60 (ASTM D287): 0.99 5. pH (EPA 150.1): 7.54 6. Surface Active Agents: Confidential 7. Solvents: Confidential 8. Additives: None 9. Solubility in Water: Dispersible in fresh and salt water. Miscible in oil, water, and solvents. |
X. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|